INSTALLATION CONDITION INSPECTION
Toyota Class 301 has been updated to help you repair the Blind Spot Monitor Sensor (BSMS) bracket to OEM speciﬁcations. Whenever you repair the BSMS, it is critical that the rear Blind Spot Monitor Sensor is properly oriented to ensure a successful repair. If you have previously taken this class, retaking it will ensure you beneﬁt from the new repair information. Follow the steps below to properly repair the BSMS.
STEP 1: From the center of the emblem on the rear bumper, hang a weight with a pointed tip. Mark the rear center point of the vehicle on the ground (mark “A”).
STEP 2: From the center of the emblem on the front bumper, hang a weight with a pointed tip. Mark the front center point of the vehicle on the ground (mark “B”).
STEP 3: Use a string to draw a center line that passes through marks “A” and “B.” Lightly ﬂick the string several times to conﬁrm that it is aligned with marks “A” and “B.”
STEP 4: Hang a string with a weight from the Blind Spot Monitor Sensor (BSMS) bracket (front and rear studs) and mark the positions on the ground.
STEP 5: At a 90-degree angle, measure from the centerline of the vehicle (string) to the marked positions on the ground.
STEP 6: Using masking tape, write the measurements on the marks on the ground. Measurements must be done in millimeters.
STEP 7: Compare the measurements to the “Speciﬁed Value” in the repair manual illustration.
Front of the bracket 800 mm
Rear of the bracket –715 mm
= 085 mm
The “Speciﬁed value” in the repair manual (on position “Y”) is 78 to 87 mm. Illustration shows the view from above.
STEP 8: Perform a “Blind Spot Monitor Sensor Installation Condition Inspection” to conﬁrm that the sensor is perpendicular to the ﬂoor (+/- 5 degrees). Using a jig, conﬁrm the sensor is 46 to 54 degrees from the line parallel to the vehicle centerline.
FOR MORE INFORMATION
Find class 301: Non Structural with Blind Spot Monitor Sensor Installation Condition Inspection Repair Procedures at Toyota’s training website— www.crrtraining.com.
Find all the speciﬁc procedures and measurements to repair the BSMS in the Toyota repair manual.